Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Bgrmystr2

Pages: [1]
1
HyperCam / Hypercam bar on task bar doesn't appear anymore.
« on: September 15, 2013, 11:43:44 AM »
I was going to open this as my statement..

First off, specs ahoy.
So, I've got Version 3.5.1211.29 of Hypercam.

Windows 7 Ultimate 64bit (currently in use)
Windows XP SP3
AMD Phenom II x4 955 3.2ghz quad
MSI Superpipe Geforce GTX 285
4gb of DDR3 ram

I can record audio from the computer as well as from my microphone. XP couldn't do that. No big deal. Problem with 7 is that it will not give me any options to record other than completely uncompressed video. I can record uncompressed video at 10 and 15fps with very little framerate slowdown while recording full 1080p. The resulting video I recorded not only skips every few seconds, but also freezes sometimes too. The audio skips as well, though not as much. The video studder becomes more fluid but also more skippy with higher framerate, and my in-game framerate slows when recording at a higher fps.

What weirded me was that the only post I could find whatsoever was on the Hypercam 2 forums, and it was because the 32bit and 64bit programs couldn't see the codecs of the opposite bit. When I downloaded Hypercam 2 version 2.28.01, both 32bit and 64bit, they both see the exact same codecs that Hypercam 3.5 cannot.


After this was posted, opening the program again to take a screenshot of the error.. it asked to register the key again. After registering the key, it reads all of the available codecs. What I realize is that when I uninstalled Hypercam 2 with Revo Uninstaller, it deleted files that belonged to Hypercam 3.

I used Revo to reinstall Hypercam 3, and the first message I got after installing was something failed to launch because it needed to be elevated, yet the program loaded no problem. At first none of my preferences stayed upon closure of the program, and the bar on the task bar wouldn't open upon minimizing the program. I restarted the computer to see if it would fix it, and now my preferences stay as they should, but the bar still doesn't appear when minimized. I believe it was the error message that needed elevation, but don't know how to resolve it.

A friend of mine, when booting Hypercam 3, all of his programs freeze, including hypercam, and stop responding. Sometimes he can get away with closing them, but other times he has to restart. He's reinstalled using Revo multiple times, and it's the same result every time. I'm not sure what to suggest here for him.

Pages: [1]